Passive electrical components

Standard

Variable designs, upon request.

Type 100

Type 11(0)

Type 12(0)

Type 13(0)

Type 14(0)

Type 15(0)

without Crimp

with Crimp

Snap-In

Stand-Off

Corner moulding

Dimensions:

RM (pitch)

2.5 mm to 80 mm;

H (height)

5.0 mm to 50 mm;

D (diameter)

0.45 mm to 2 mm;

Measuring point:

1.5 mm under the mounting point, other types possible;

Pin length:

3 mm, other lengths possible.

Resistance range:

4 mΩ to 100 mΩ.

Power range:

0.3 W; 1 W; 2 W.

Tolerance:

10 %; 5 %; 3 %.

Design:

These shunts, including the pins, are manufactured in materials as designated below. No welding is done and no significant thermal stress occurs. The design of the contact point is designated according to specification (requirements). Special designs are possible at any time.

Application:

Switching power units, Frequency converters, Automotive applications, Current supplies

Features:

Low cost design; many possible pin forms (e.g. Snap-In, Stand-Off); broad resistance range and power range.

Applied materials

Temperature-coefficient [ppm/degree]

Thermal voltage against Cu [µV/K]

specific resistance [Ω * qmm/m]

maximum working temperature

Isotan

-80 to + 40

-40

0.49

350 °C

Nickelin-W

+80 to +130

-25

0.40

500 °C

Isazin

+180

-30

0.30

500 °C

Temperature range:

-55 °C to +350 °C.

Load reduction:

linear from 70 °C to 350 °C (0 Watt).

Long-time constancy:

<3% dependent upon the resistance material.

Solder ability:

applicable for wave solder baths (at temperatures >420°C and use of special flux additament).

Packaging:

bulk goods, if necessary shrink-wrapped in polyethylene bags; under certain conditions belt-roll is possible.

(With low-resistance values, respectively with high loading the diameter of the leads (pins) is relatively large. Before ordering the belt-roll, please check that your processing machine is able to cut the pin).